AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Apple pi baker needs admin password12/10/2023 Please message me with more details that you learn as I have never tried this with an Olimex board (I've done the same basic procedure on a Beagle Bone Black). The display will also tell you to remove the sd card and reboot.Īfter all this you probably want to update to the latest firmware as I'm not sure that the link above will always be the latest but the printer will know if it is the latest or not. Perform a clean install of Windows.This type of installation will remove Windows from your computer and install it again from scratch. Now, booting up (only once) with the sd card inserted, wait until a green light goes on on the led ring around the control knob. In order to reach it you will need to remove the micro USB cable in front of it The SD card slot is located on the smaller board in the back. Then, removing the plastic cap in front of the olimex board (it is located on the bottom of your printer), find the SD card slot and insert the SD card: Once that is done you can put the SD card back in the printer and check if it boots correctly.Use the IMG recipe section and search for the file.Insert the Micro SD card in your computer. If you are working with MacOS, you can better use ApplePie baker: Here is a nice guide on putting a disk image on a sd card: If the below procedure doesn't work I have MUCH more detailed debugging information here: gr5.org/unbricking/Īsk your reseller for the latest recovery image for your particular printer version. Copied from someone else - I didn't write 99% of what is below but I think it's very useful - especially if you are messing with json files on your UM3/S3/S5/UM2+C and it stops booting.
0 Comments
Read More
Leave a Reply. |